Today, I laid out the bottom panels on both sheets one and two and cut out the plywood for frames 2, 4, and 9 ??
batten in place and lines marked for cutting.
All the lines that were marked were cut out with the circular saw. I find it best not to set the saw too deep.
saw is set to cut no more than 1.5 teeth deep.
???? ??The next step involves cutting out one half and using it as a template for the other half. After cutting the lines are faired up with a small block plane and a Stanley surform. This makes short work of it and keeps the operator warm on a winters day (its 20 degrees Farenheit today).
The same process is used on the next piece of plywood to get out the forward halves of the bottom.
One more piece of plywood left. We start by ripping it down the middle and marking our straight edges from which we will be measuring. From this piece we will get the sides, the transom, and one half of frame 6. I will cut these out next weekend if time allows.
panels in the workshop waiting for the sides to join them. It is much warmer in here and thus better for gluing.
0 komentar:
Posting Komentar