Make Sure to Use Plenty of Epoxy

CrappyGluing
Originally uploaded by OzzyC.

After we cut the excess length off of the rear transom, we decided to test the strength of the epoxy. I figured a drop test would be the best way to get a guage of how strong our gluing job was, and I was concerned with the results.

I dropped the excess from about five feet, to see how well it would hold up to a shock. The results werent good. One of the four layers completely broke away. The second layer, as shown in this picture, split about 2/3 of the way through.

The moral of the story?? Use more glue than we did. In order to compensate for the lack of glue, we are going to reinforce the rear transom with several bronze screws. Were going to use bronze screws because they wont corrode over time.

Read More..

Crazy from the Heat

Shaved Hull
Originally uploaded by OzzyC.

Like I said in my last entry, this heats a killer. We started at around 7:30 and put in about 2 and a half hours. What did we accomplish? Unfortunately not too much.

When we did our test fit last weekend, we saw that the bottom panels were about two inches too wide. So this week we (actually it was just Greg) built a jig so we could draw a line along the hull without removing the sides that wed strapped on, and then we ran a circular saw along the length of the bottom panels and shaved off the extra. In short, we finished about 1/2 hour worth of work in about 2 and a half hours.

Read More..