I went to Gregs for another round of work last night. When I got there, I saw something that almost made me burst out in tears. Greg had virtually cut the boat in half.
After rolling the boat, Greg measured the width of the boat, and it was something like eight and a half feet wide, roughly six inches over the maximum width allowed without getting a permit to tow a wide load. Greg had originally decided to risk it... after all, the width would be difficult at best to measure. Apparently he changed his mind.
In order to get the width reduced, Greg put a relief cut in each side, from the top to about three inches from the bottom. He then used straps to pull the hull to the width he wanted, and then filled the relief cuts with thickened epoxy and re-taped the hull, inside and out. He cut through the spray rail and everything.
Its his boat, so he can do what he wants. But had I known what he was thinking, Id have done everything in my power to talk him out of doing that. We could have used straps and epoxy and pulled the hull in, attaching it to the frame pieces, and things would have been much less invasive. Additionally, the bottom is probably ever-so-slightly hooked now, and the spray rails will likely have a noticeable bend at the cutting point. The biggest thing though, is the fact that were going to have to re-sand and re-paint this scar, and probably re-tape it a couple more times as well.
I almost cried.
Read More..
After rolling the boat, Greg measured the width of the boat, and it was something like eight and a half feet wide, roughly six inches over the maximum width allowed without getting a permit to tow a wide load. Greg had originally decided to risk it... after all, the width would be difficult at best to measure. Apparently he changed his mind.
In order to get the width reduced, Greg put a relief cut in each side, from the top to about three inches from the bottom. He then used straps to pull the hull to the width he wanted, and then filled the relief cuts with thickened epoxy and re-taped the hull, inside and out. He cut through the spray rail and everything.
Its his boat, so he can do what he wants. But had I known what he was thinking, Id have done everything in my power to talk him out of doing that. We could have used straps and epoxy and pulled the hull in, attaching it to the frame pieces, and things would have been much less invasive. Additionally, the bottom is probably ever-so-slightly hooked now, and the spray rails will likely have a noticeable bend at the cutting point. The biggest thing though, is the fact that were going to have to re-sand and re-paint this scar, and probably re-tape it a couple more times as well.
I almost cried.
